Class II Laser Diode Module for IEC 60825-1, EN 60825-1, and JQA (Japan Quality Assurance) compliances 

KEY FEATURE -  

Meets Single Fault Failure Requirements: 
IEC (International Electrotechnical Commission) 60825-1 is applicable to safety of laser products emitting laser radiation in the wavelength range 180 nm to 1 mm.

IEC 60825-1, EN 60825-1, and  JQA require the laser products to meet Single Fault Failure Requirements, which require the highest emitted power under reasonably foreseeable single fault failure conditions never  higher than the laser classification.  Therefore, for class II or class 2 laser products, the output power is <1mW, the highest emitted power under reasonably foreseeable single fault failure conditions for this laser shall never be >1mW.

Obviously, the driver PCB for diode lasers is of importance, in the case of a flaw or defect, it may cause the laser product to emit above the AEL (accessible emission limit) of the desired Class.  Our PS series laser diode modules with the thought of safety  would eliminate this risk and keep the laser in the safe range as required.

The following PS-series class II laser diode modules are designed with the driver PCB to meet Single Fault Failure Requirements for IEC 60825-1, EN 60825-1,  and JQA.


3-9V DC Operating voltage version

Note: This driver PCB can be used in our PL- and LS- series laser diode modules to meet Single Fault Failure Requirements for IEC 60825-1, EN 60825-1, and  JQA also, if required.

 

 

 

 
PRODUCTS
   
CONTACT US
Lasermate Group, Inc.
19608 Camino De Rosa
Walnut, CA 91789, USA
Tel: (909) 718-0999
Fax: (909) 718-0998
Email:
info@lasermate.com
HOW TO ORDER | QUO & INFO REQUEST | TERMS & CONDITIONS



Information contained herein is considered typical data. Lasermate Group, Inc. reserves the right to change or modify specifications of products at any time without notice.

Copyright by Lasermate Group, Inc.. All rights reserved.